reducer企業承諾守信,圣霖國際優質服務

在安裝時，嚴禁用鐵錘等擊打，防止軸向力或徑向力過大損壞軸承或齒輪。一定要將安裝螺栓旋緊之后再旋緊緊力螺栓。

At the time of installation, it is strictly prohibited to use a hammer, such as a hammer, so as to prevent the axial or radial force from damaging the bearing or gear. It is necessary to tighten the bolt when the bolt is tightened.

在電機與減速機連接前，應先將電機軸鍵槽與緊力螺栓垂直。為保證受力均勻，先將任意對角位置的安裝螺栓旋上，但不要旋緊，再旋上另外兩個對角位置的安裝螺栓后逐個旋緊四個安裝螺栓。

Before connecting the motor to the reducer, the key slot of the motor shaft should be perpendicular to the tightening bolt first. To ensure uniform force, screw the mounting bolts at any diagonal ition first, but do not tighten them. Then screw the mounting bolts on the other two diagonal iti, and tighten the four mounting bolts one by one.

減速機的種類：一般的減速機有斜齒輪減速機(包括平行軸斜齒輪減速機、蝸輪減速機、錐齒輪減速機等等)、行星齒輪減速機、擺線針輪減速機、蝸輪蝸桿減速機、行星摩擦式機械無級變速機等等。

Type of reducer

The general reducer has helical gear reducer (including parallel shaft helical gear reducer, worm gear reducer, bevel gear reducer, etc.), planetary gear reducer, cycloid pin reducer, worm gear reducer, planetary friction mechanical stepless speed change machine and so on.

對減速機箱體進行共振測試，找出共振位 置，增加適當?shù)慕顥l（板），可以提高箱體的剛度，減少箱體的振動，實現降噪。多級傳動時要求瞬時傳動比的變化盡量小，以保證傳動平穩，沖擊及振動小，噪聲低。

By testing the resonance of the reducer box, finding out the resonance  and adding appropriate ribs (plates), the stiffness of the box can be increased, the vibration of the box can be reduced and the noise can be reduced. In multistage transmission, the change of instantaneous transmission ratio should be as small as  to ensure stable transmission, low impact and vibration, and low noise.